{{statusText}}
{{statusText}}
jq77983

How to remove a Fibaro FGMS-001 ZW5 Motion Sensor to a Z-Wave network?

Note: {{noteText}}
{{noteText}}
 
 
  •  
  •  
  •  
Answered by Mark Turner
0 Upvotes

Follow the below procedure for the Exclusion of Fibaro FGMS-001 ZW5 Motion Sensor to a Z-wave network:

  1. Make sure your sensor is within the range of the Z-Wave interface controller.

  2. Gently remove the back cover of the motion sensor.

  3. Set the Z-wave controller in Exclusion/remove mode - go through the instruction manual of the manufacturer.

  4. Press the B-Button three times to put the motion sensor in the learning mode. You should see the LED diode turning blue.

  5. Once the Exclusion process is successful, you’ll get a confirmation message/notification from the Z-wave interface controller.


type caption for image (optional)
B-Button on Fibaro FGMS-001 ZW5 Motion Sensor




 
jca66542
Note: {{noteText}}
{{noteText}}
Written 4 years ago
 
 
  •  
  •  
  •  
Scroll Down